HI I have a Caponord ETV 1000 2006 model.
Could you please tell me how to reset the service light.
The bike was serviced at 1000 miles.
TAlso I have been
trying to obtain two Aprilia badges for my jackets.
Could you please let me
know how to obtain two of them.
Many thanks Mr.C.Campbell.
How to reset the service light ?
-
luca
- Detto LUCAWEB
- Messaggi: 1648
- Iscritto il: mercoledì 12 dicembre 2001, 1:00
- Località: Empoli
- Contatta:
How to reset the service light ?
Una cosa che non senti mai menzionare riguardo ai pionieri
è che essi sono, invariabilmente, per loro stessa natura,
dei casinari. (Pirsig)
noi di AOTR siamo Pionieri (LucaWeb)
-------------------------------------------------------
Nessuna buona azione resterà impunita. (D.H.)
-------------------------------------------------------
è che essi sono, invariabilmente, per loro stessa natura,
dei casinari. (Pirsig)
noi di AOTR siamo Pionieri (LucaWeb)
-------------------------------------------------------
Nessuna buona azione resterà impunita. (D.H.)
-------------------------------------------------------
-
attila
- STAFF
- Messaggi: 4532
- Iscritto il: mercoledì 30 gennaio 2002, 1:00
- Moto: Caponord ETV1000
- Località: Belluno
RST1000 Futura / ETV1000 CapoNord
Re-setting the "SERVICE" Light
1. Remove the seat.
2. On the right hand side (as you face the bars) near the battery you will find two connectors. One each, male and female. The female connector has two grey wires and the male has a blue/green wire. Connecting these two together puts the onboard computer into diagnostic mode. Connect these together, noting their original position for later.
3. Turn on the ignition (don't start the engine).
4. On the right hand instrument panel, "EFI" will now display above the MODE button.
5. Press and hold the MODE button.
6. While still pressing the MODE button, press and hold the SET button.
7. Keep both buttons pressed until the "Service" indicator disappears (seems like a long time, 10+ seconds).
8. Turn off the ignition.
9. Disconnect the diagnostic connectors and place them in their original position.
10. Turn ignition back on to verify "SERVICE" indicator is out and panel displays normally.
11. Replace seat and ride safely.
Re-setting the "SERVICE" Light
1. Remove the seat.
2. On the right hand side (as you face the bars) near the battery you will find two connectors. One each, male and female. The female connector has two grey wires and the male has a blue/green wire. Connecting these two together puts the onboard computer into diagnostic mode. Connect these together, noting their original position for later.
3. Turn on the ignition (don't start the engine).
4. On the right hand instrument panel, "EFI" will now display above the MODE button.
5. Press and hold the MODE button.
6. While still pressing the MODE button, press and hold the SET button.
7. Keep both buttons pressed until the "Service" indicator disappears (seems like a long time, 10+ seconds).
8. Turn off the ignition.
9. Disconnect the diagnostic connectors and place them in their original position.
10. Turn ignition back on to verify "SERVICE" indicator is out and panel displays normally.
11. Replace seat and ride safely.
Mandi!
Attila
CN Grigio Dust Marzo 2002
"black snaky"
Attila
CN Grigio Dust Marzo 2002
"black snaky"